5.11 Report options
Figure 46 represents an overview of the Report options tab. Within this section of the GUI you need to specify for each variable if you want this to be reported as model output yes or no. The left side of this section shows a list with all the variables that can be reported as model output.
The right side of this section shows the options for the model output settings, which are divided into:
Map-series output
Time-series output
Report mm fluxes for basin averages
Under map-series output you can specify whether you want output maps to be reported on a daily, monthly, or annual basis. In the example above it can be seen that baseflow runoff is reported on both a monthly and annual basis.
Additionally, you may be interested in plotting time-series for certain variables on locations defined in the Stations map under Catchment settings. If this is required, then you need to check the Daily box under the Time-series output option.
Another interesting option is to report mm fluxes for basin averages. It is often more useful to analyze fluxes in mm than comparing fluxes in m3/s. The “Report mm fluxes for basin averages” calculates for the areas upstream of your locations, which are defined in your Stations map, basin average fluxes in mm. This calculation will only be done for the in- and outgoing fluxes, which are: precipitation, actual evapotranspiration, glacier melt, routed snow runoff, routed rain runoff, routed glacier runoff, routed baseflow runoff, and routed total runoff.
After the reporting options have been set you can continue with the next tab: Run Model.
Last updated